A Comprehensive Review and Comparative Study of Various Rib Configurations Used in Rectangular Duct for Heat Transfer Enhancement
DOI:
https://doi.org/10.51983/arme-2022.11.1.3331Keywords:
Heat Transfer Enhancement, Overall Enhancement Ratio, Ribs, Reynolds Number, Turbulent Flow, TurbulatorsAbstract
This research study provides a comprehensive review of various heat transfer enhancement techniques that are being used by various researchers for enhancing heat transfer rate and overall thermal performance factor of the heat exchangers. Based on the present review study, it can be concluded that intensive study has been carried out by various researchers to determine the effect of various rib geometries on the heat transfer enhancement and friction factor characteristics of rectangular duct. The enhancement in the heat transfer rate is obtained by introducing the blockages or restrictions in the fluid flow path by providing various rib turbulator configurations. This research paper puts highlights on the various heat transfer enhancement techniques are used for increasing overall thermal performance factor in the heat exchangers. Introduction of ribs as flow disturber results not only into increase in heat transfer surface area but also into increased turbulence, recirculation of working media, viscous effect and secondary flow that results into swirl. The interruptions or blockages created by ribs provided in the flow channel results into increased pressure drop and disruptions in boundary layer development. Provision of ribs also causes secondary flow which ensures enhanced thermal contact between working fluid and surfaces of the flow channel. This results into increase in heat transfer coefficient and thermal performance of heat exchanger respectively.
References
T. T. Wong, C. W. Leung, Z. Y. Li, and W. Q. Tao, "Turbulent convection of air-cooled rectangular duct with surface-mounted cross-ribs," International Journal of Heat and Mass Transfer, vol. 46, pp. 4629-4638, 2003.
Z. X. Yuan, W. Q. Tao, and X. T. Yan, "Experimental Study on Heat Transfer in Ducts with Winglet Disturbances," Heat Transfer Engineering, vol. 24, no. 2, pp. 76-84, 2003.
J. Ahn, H. Choi, and J. S. Lee, "Large Eddy Simulation of Flow and Heat Transfer in a Channel Roughened by Square or Semicircle Ribs," Journal of Turbomachinery (ASME), vol. 127, pp. 263-269, 2005.
L. Wang and B. Sunden, "Experimental investigation of local heat transfer in a square duct with various-shaped ribs," Heat and Mass Transfer (Springer), vol. 43, pp. 759-766, 2007.
K. R. Aharwal, B. K. Gandhi, and J. S. Saini, "Experimental investigation on heat-transfer enhancement due to a gap in an inclined continuous rib arrangement in a rectangular duct of solar air heater," Renewable Energy (Science Direct), vol. 33, pp. 585-596, 2008.
S. Eiamsa-ard and W. Changcharoen, "Analysis of Turbulent Heat Transfer and Fluid Flow in Channels with Various Ribbed Internal Surfaces," Journal of Thermal Science, vol. 20, no. 3, pp. 260-267, 2011.
G. Tanda, "Effect of rib spacing on heat transfer and friction in a rectangular channel with 45° angled rib turbulators on one/two walls," International Journal of Heat and Mass Transfer, vol. 54, pp. 1081-1090, 2011.
S. Chamoli and N. S. Thakur, "Thermal behavior in rectangular channel duct fitted with V-shaped perforated baffles," Heat Transfer Engineering, vol. 36, no. 5, pp. 471-479, 2015.
O. Yemenici and H. Umur, "Experimental aspects of heat transfer enhancement over various flow surfaces," Heat Transfer Engineering, pp. 1-33, 2015.
A. K. Shukla and A. Dewan, "Computational study of heat transfer enhancement through broken and continuous attached ribs in a square channel," in Proceedings of the 23rd National Heat and Mass Transfer Conference and 1st International ISHMT-ASTFE Heat and Mass Transfer Conference, Paper No. IHMTC 2015-350, 17-20 December 2015.
A. Shukla and A. Dewan, "Computational study on effects of rib height and thickness on heat transfer enhancement in a rib roughened square channel," Indian Academy of Sciences, DOI: 10.1007/s12046-016-0501-z, 2016.
R. Kumar, A. Kumar, A. Sharma, R. Chauhan, and M. Sethi, "Experimental study of heat transfer enhancement in a rectangular duct distributed by multi V-perforated baffle of different relative baffle width," Heat and Mass Transfer (Springer), DOI: 10.1007/s00231-016-1901-7, 2016.
Downloads
Published
How to Cite
Issue
Section
License
Copyright (c) 2022 The Research Publication
This work is licensed under a Creative Commons Attribution-NonCommercial-NoDerivatives 4.0 International License.
